The RB2011 is a low cost multi port device series, powered by RouterOS, a fully featured routing operating system which has been continuously improved for fifteen years. Dynamic routing, hotspot, firewall, MPLS, VPN, advanced quality of service, load balancing and bonding, real-time configuration and monitoring - just a few of the vast number of features supported by RouterOS.
RouterBOARD 2011UiAS-2HnD has most features and interfaces from all our Wireless routers. It’s powered by the new Atheros 600MHz 74K MIPS network processor, has 128MB RAM, five Gigabit LAN ports, five Fast Ethernet LAN ports and SFP cage (SFP module not included!). Also, it features powerful 1000mW dual chain 2.4Ghz 802.11bgn wireless onboard, RJ45 serial port, microUSB port and RouterOS L5 license.
There are two MMCX connectors for adding external antennas, so you can create powerful dual chain wireless backbone, AP or CPE unit.
There is PoE output function for port #10 - it can power other PoE capable devices with the same voltage as applied to the unit. Maximum load on the port is 500mA.
Tested and recommended to use with MikroTik SFP modules: S-85DLC05D, S-31DLC20D and S-35/53LC20D (not included)
|CPU nominal frequency||600 MHz|
|CPU core count||1|
|Size of RAM||128 MB|
|10/100 Ethernet ports||5|
|10/100/1000 Ethernet ports||5|
|Wireless chip model||AR9344-DC3A|
|Number of USB ports||1|
|Power Jack||8-28V DC|
|PoE in||8-28V DC on Ether1|
|PCB temperature monitor||Yes|
|Dimensions||214mm x 86mm|
|Tested ambient temperature||-35C to +65C|
|Max Power consumption||15W|
|USB slot type||microUSB type AB|
|Number of chains||2|
Ethernet test results
|RB2011UiAS-2HnD||AR9344 1G&100M all port test|
|Mode||Configuration||1518 byte||512 byte||64 byte|
|Bridging||none (fast path)||122.0||1,481.6||232.0||950.3||269.6||138.0|
|Bridging||25 bridge filter rules||83.6||1,015.2||86.0||352.3||87.6||44.9|
|Routing||none (fast path)||122.0||1,481.6||210.0||860.2||226.9||116.2|
|Routing||25 simple queues||100.5||1,220.5||103.9||425.6||106.6||54.6|
|Routing||25 ip filter rules||56.8||689.8||59.6||244.1||60.5||31.0|
- All tests are done with Xena Networks specialized test equipment (XenaBay),and done according to RFC2544 (Xena2544)
- Max throughput is determined with 30+ second attempts with 0,1% packet loss tolerance in 64, 512, 1518 byte packet sizes
- Values in Italic indicate that max throughput was reached without maxing out CPU, but because board interface configuration was maxed out
- Test results show device maximum performance, and are reached using mentioned hardware and software configuration, different configurations most likely will result in lower results